Signals (Output Signals); Status Signals (Output Signals) - AUMA SG Series Operation Instructions Manual

SG 04.2 SG 10.2
with actuator controls MEC 03.1
11.

Signals (output signals)

11.1.

Status signals (output signals)

Up to 4 programmable semi-conductors or relay outputs are available, each with
max. 30 V/1 A switching power.
Table 16:
Exemplary assignment of 4 outputs
Designation of output contacts in wiring dia-
gram
K 1 = End position OPEN
K 2 = End position CLOSED
K 3 = Fault
K 4 = REMOTE
(only for version with local controls)
Signals (output signals)
Designation of output contact in AUMA CDT software
Signal DOUT 2 = End position OPEN
Signal DOUT 1 = End position CLOSED
Signal DOUT 3 = Fault
Signal DOUT 4 = Selector sw. REMOTE
39