AUMA SG Series Operation Instructions Manual page 36

Operation and control of actuator
36
Figure 33: Local controls
[1] Push button OPEN
[2] Push button STOP - operation mode LOCAL/REMOTE
[3] Push button CLOSE
[4] Indication light for operation mode LOCAL (blue)
Hot surfaces, e.g. possibly caused by high ambient temperatures or strong
direct sunlight!
Risk of burns
Verify surface temperature and wear protective gloves.
Activate operation mode LOCAL:
Hold down push button [2] for approx. 3 seconds until the indication light [4] is
blinking in blue.
If the right indication light is blinking in blue, the actuator can be operated via
push buttons [1 3]:
- Run actuator in direction OPEN: Press push button OPEN [1].
- Stop actuator: Press push button STOP [2].
- Run actuator in direction CLOSE: Press push button CLOSE [3].
SG 04.2 SG 10.2
with actuator controls MEC 03.1