Auma Cdt Software (Accessories) - AUMA SG Series Operation Instructions Manual

AUMA CDT software (accessories)

12. AUMA CDT software (accessories)
40
The AUMA CDT software (accessories) can be used to establish a connection to a
computer (notebook or tablet).
AUMA CDT software can be downloaded free of charge from our website
www.auma.com. For the supported actuator ranges, refer to our website.
For connecting the computer to the actuator controls, a service cable is required.
Read/perform basic settings via AUMA CDT software
Basic settings at the device (in actuator controls) made via switches are read only
via AUMA CDT on delivery and cannot be modified. To be able to change these
parameters via software, set switch [S5] in actuator controls to "Software mode." ⇨
page 29, Setting via hardware (switches) or via software
Switches and software parameters are set to the same values upon delivery (factory
settings).
SG 04.2 SG 10.2
with actuator controls MEC 03.1