Indication Lights On Local Controls Of Mec 03.1 - AUMA SG Series Operation Instructions Manual

Indications
10.2.

Indication lights on local controls of MEC 03.1

38
Figure 35: Indication lights on local controls of MEC 03.1(option)
[1] Indication light OPEN/fault (green/red)
[2] Indication light CLOSE/LOCAL (yellow/blue)
Table 14:
Indication light [1] (default setting)
Colour/state Signification
illuminated in green OPEN
blinking in red Fault
Table 15:
Indication light [2] (default setting)
Colour/state Signification
illuminated in yellow CLOSE
blinking in blue (1 LOCAL
Hz)
with actuator controls MEC 03.1
Description
The actuator is in end position OPEN.
The number of blinking signals indicates the number of fault
signal. Refer to <Corrective action> chapter.
Description
The actuator is in end position CLOSED.
Operation mode LOCAL is active. The actuator can be operated
using the push buttons of local controls.
SG 04.2 SG 10.2