Table of Contents
Advertisement
Basic settings for the actuator controls
8.
Basic settings for the actuator controls
8.1.
Actuator controls: open/close
open
28
To prevent valve damage and failures during commissioning, the basic settings of
actuator controls must be verified prior to electrical actuator operation (motor
operation) and adapted in compliance with the requirements of both valve and
application.
Basic settings of the actuator controls include:
Setting hardware (switches) or software mode
Setting the type of seating
Setting the torque switching
Setting the operating time
To perform basic settings, proceed as follows:
1.
via switches (directly at the device);
For switch setting, open actuator controls cover.
2.
via AUMA CDT software (with computer/notebook, tablet);
⇨
page 6, Software
www.auma.com)
For changing switch settings, open actuator controls cover.
Electric shock due to presence of hazardous voltage!
Failure to observe this warning results in death or serious injury.
Disconnect device from the mains before opening.
Wait for 60 seconds after power cut-off prior to opening the housing.
1.
Loosen 4 screws and remove cover [1] to actuator controls.
Figure 26:
2.
Clean sealing faces of housing and cover.
3.
Apply a thin film of non-acidic grease (e.g. petroleum jelly) to the sealing faces.
4.
Check whether seal is in good condition, replace seal if damaged.
5.
Apply a thin film of non-acidic grease (e.g. petroleum jelly) to the seal and insert
correctly.
6.
Place cover [1].
7.
Fasten screws evenly crosswise.
(Software versions can be downloaded from
SG 04.2
SG 10.2
with actuator controls MEC 03.1
Advertisement
Table of Contents
