AUMA SG Series Operation Instructions Manual page 16

Electrical connection
16
Figure 14: Connections at actuator
[XA1] 5 contacts, socket for motor power plug
[XA2] 17 contacts, socket for signal connector
Suitable connectors
If indicated on the order, suitable connectors for the connections XG1]
be supplied. The cable diameter must be indicated on the order.
For the pin assignment (A, B, C, ...) for connecting the cables and wires to the
connector, refer to the enclosed wiring diagram. For further data such as terminal
cross sections, cable diameters and tools e.g. crimping pliers refer to separate
Technical data "ITT Cannon connector" (AUMA document number: Y007.274)
Hazardous voltage at open connector (capacitor discharge)!
Risk of electric shock.
After disconnecting the power supply (removing connector for power terminals),
wait at least 5 seconds before touching the pins/sockets.
SG 04.2 SG 10.2
with actuator controls MEC 03.1
[XG4] will