Setting Items - Mitsubishi Electric MELSEC Q Series Reference Manual

2 SYSTEM CONFIGURATION

2.4.2 Setting items

2 - 11
(1) Table 2.7 lists the setting items for the master module main module for a remote
master station (MR) and the parameter settings from the GX Developer.
Table 2.7 Remote master station setting items
Setting items
Network module main module switch
STATION NO.
MODE
Parameter setting on GX Developer
Setting the number of Ethernet/CC IE/MELSECNET cards
Network type
Starting I/O No.
Network No.
Total number of remote modules
Group No.
Mode
Common parameters
Supplementary setting
Station specific parameters
Refresh parameters
Valid module during other station access
Inter-link data transfer parameters
Routing parameters
: Always set,
1: Default values are not set in LX/LY. Set the refresh parameters.
2: Default values are preset for LB/LW.
The CPUs other than the Universal model QCPU may operate even if refresh
parameters have not been set.
For the operation and precautions, refer to Section 5.1.5 (3).
3: Refer to the Q Corresponding MELSECNET/H Network System Reference
Manual (PLC to PLC Network) (SH-080049).
Remote master station (M
MELSECNET/H
(Remote master station)
: Default setting, : Set as needed,
MELSEC-Q
) Reference
R
0 Section 4.2.1
Section 4.2.1
Section 5.1.1
Section 5.1.2
Section 5.1.2
Section 5.1.2
—
Section 5.1.2
Section 5.1.3
Section 5.1.4
—
1 2 Section 5.1.5
Section 5.1.6
—
: No need to set
2 - 11
3