Mitsubishi Electric MELSEC Q Series Reference Manual page 192

5 PARAMETER SETTINGS
5 - 35
(a) Operational settings
1) Remote I/O switch setting
For future expansion. Cannot be set at present time.
2) Assignment method
Select the assignment method for sending parameters between
devices: "Points/Start" or "Start/End".
• Assign the bit device (B, M) points in increments of 16 and the
start/end addresses with the number in multiples of 16.
3) Forwarding parameter between devices
This sets the type of device and transfer range when data transfer is
performed between internal remote I/O module devices. Up to 64 units
can be set.
With the basic setting, when the intelligent function module buffer
memory data is automatically refreshed to the remote I/O module data
register D, that data is used if there data transfer to link register W. It
is also used when link register data W data is transferred to data
register D.
MELSEC-Q
5 - 35