Mitsubishi Electric MELSEC Q Series Reference Manual page 160

5 PARAMETER SETTINGS
5 - 3
Table 5.1 Remote master station network parameter setting items
Parameter setting item
Settings with the network module
Station number (STATION No.)
Mode (MODE)
Settings with GX Developer
Setting the number of modules (network type)
Network settings
Starting I/O No.
Network No.
Total stations
Group No.
Mode
Common parameters
Send range of each station (LX/LY settings)
Send range of each station (LB/LW settings)
Specify reserved station
Supplementary settings
Constant link scan
Maximum No. of returns to system stations in 1
scan.
Multiplex transmission designation
Block send data assurance per station
Block receive data assurance per station
END asynchronous settings
Transient settings
Refresh parameters
Valid module during other station access
Interrupt settings
Redundant settings
Routing parameters
: Always set : Default setting exists
3: Default values are not set for LX/LY. Set the refresh parameters.
4: Default values are preset for LB/LW.
The CPUs other than the Universal model QCPU may operate even if
refresh parameters have not been set.
For the operation and precautions, refer to Section 5.1.5 (3).
5: For details, refer to the Q Series MELSECNET/H Network System
Reference Manual (PLC to PLC Network).
REMARKS
Always write network parameters to the remote master station.
Network station type
Remote master station
: Set as needed
MELSEC-Q
Reference
section
—
Section 4.3
Section 4.3.1
Section 4.3.2
—
Section 5.1.1
—
Section 5.1.2
Section 5.1.2 (1)
Section 5.1.2 (2)
Section 5.1.2 (3)
Section 5.1.2 (4)
Section 5.1.2 (5)
—
Section 5.1.3
Section 5.1.3 (1)
Section 5.1.3 (2)
Section 5.1.3 (3)
—
Section 5.1.4
Section 5.1.4
3 4 Section 5.1.5
Section 5.1.6
Section 7.7
Section 5.1.7
5
: Setting not required
5 - 3