Mitsubishi Electric MELSEC Q Series Reference Manual page 161

5 PARAMETER SETTINGS
5 - 4
Table 5.2 Remote I/O station PLC parameter setting items
Parameter setting item
PLC system
Points occupied by empty slot
Module synchronization
PLC RAS
Operating mode when there is an error
Error check
Operational settings
Remote I/O switch setting
Assignment method
Forwarding parameter between devices
I/O assignment
I/O Assignment
Standard setting
: Always set : Default setting exists
Table 5.3 Remote I/O station network parameter setting items
Parameter setting item
Ethernet
CC-Link
: Always set : Default setting exists
Table 5.4 Remote I/O station remote password setting items
Parameter setting item
Password setting
Password active module settings
: Always set : Default setting exists
Refer to the intelligent function module user's manual for details about intelligent
function module parameters.
Network station type
Remote I/O station
: Set as needed
Network station type
Remote I/O station
: Set as needed
Network station type
Remote I/O station
: Set as needed
MELSEC-Q
Reference
section
—
Section 5.2.1
—
Section 5.2.1
—
Section 5.2.1
—
Section 5.2.1
: Setting not required
Reference
section
Section 5.2.1
Section 5.2.1
: Setting not required
Reference
section
Section 5.2.1
Section 5.2.1
: Setting not required
5 - 4