Setting Items - Mitsubishi Electric MELSEC Q Series Reference Manual

2 SYSTEM CONFIGURATION

2.3.2 Setting items

2 - 8
(1) Table 2.5 lists the parameter setting items of the multiplexed remote master
station (DM ) and multiplexed remote sub-master station (DSM
R
In the redundant system, the same network parameters are set to both the
control and standby systems. For this reason, parameter setting for the
multiplexed remote sub-master station is not required.
Make sure to assign No.0 to the master module mounted on the system A CPU
in the redundant system.
Table 2.5 Setting Items of a Multiplexed Remote Master Station and
a Multiplexed Remote Sub-master Station
Setting items
Tracking cable connector
Network module switch
STATION NO.
MODE
Parameter setting on GX Developer
Setting the number of Ethernet/CC IE/MELSECNET cards
Network type
Starting I/O No.
Network No.
Total stations
Group No.
Mode
Common parameters
Supplementary setting
Station specific parameters
Refresh parameters
Valid module during other station access
Interlink data transfer parameters
Setting of redundant configuration
Routing parameters
: Always set,
1: Default values are not set in LX/LY. Set the refresh parameters.
2: Default values are preset for LB/LW.
The system may operate even if refresh parameters have not been set.
For the operation and precautions, refer to Section 5.1.5 (3).
3: Refer to the Q Corresponding MELSECNET/H Network System Reference
Manual (PLC to PLC Network) (SH-080049).
Remote master
station (M )
R
System A
0
MELSECNET/H
(Remote master
station)
1 2
: Default setting, : Set as needed,
MELSEC-Q
).
R
Remote sub-
master station Reference
)
(DSM
R
System B Section 7.1.1
1 to 64 Section 4.2.1
Section 4.2.1
Section 5.1.1
Section 5.1.2
Section 5.1.2
Section 5.1.2
—
Section 5.1.2
Section 5.1.3
Section 5.1.4
—
Section 5.1.5
Section 5.1.6
—
Section 5.1.7
3
: No need to set
2 - 8