Mitsubishi Electric MELSEC Q Series Reference Manual page 128

4 SETTING AND PROCEDURE BEFORE OPERATION
4 - 8
(b) RS-232 connector
A RS-232 cable for a peripheral is connected.
(c) Station number setting switches
These switches set the station number of the network module in the
network. (Factory default: 1)
Setting
0
1 to 64
65 to 99
POINT
(1) Station numbers within a network must be unique.
(2) Station numbers do not need to be in order. When not setting a station number,
set the station as a reserved station.
(d) Mode setting switch
This switch sets the operation mode. (Factory default: 0)
Set the mode setting switches in the same position (except the online
(MELSECNET/10 mode)) on all network modules.
1) QJ72LP25-25
Setting
0
1
2
3
4
5
6
7
8
9 to F
2) QJ72LP25G, QJ72LP25GE
Setting
0
1
2
3
4 to 7
8
9 to F
Setting error (The ERR. LED turns on (red).)
Available setting range (When the QJ72BR15 is used, setting any of 33
to 64 will result in a setting error. However, the ERR. LED does not turn
on (red).)
Setting error (The ERR. LED turns on (red).)
Online
Self-loopback test
Internal self-loopback test
Hardware test
Online (The mode selected by the parameter will be
enabled.)
Self-loopback test
Internal self-loopback test
Hardware test
Online (MELSECNET/10 mode)
Use prohibited
Online
Self-loopback test
Internal self-loopback test
Hardware test
Use prohibited
Online (MELSECNET/10 mode)
Use prohibited
MELSEC-Q
Description
Description
Description
Communication
speed: 10Mbps
Communication
speed: 25Mbps
4 - 8