Mitsubishi Electric MELSEC Q Series Reference Manual page 159

5 PARAMETER SETTINGS
(2) Parameter settings for a remote I/O station
Not required
required
1) If no parameters are written to the remote I/O station, operation is performed
2) Resetting the CPU module of the remote master station or changing the status
3) Even if only one of the following settings is corrected, all the parameters are
5 - 2
functions as necessary.
PLC Parameters
(1) PLC system
(2) PLC RAS
(3) Operational settings
(4) I/O assignment
Intelligent function module parameter settings
functions as necessary.
Not
Network parameter settings
(1) Ethernet
(2) CC-Link
Setting a remote password.
Writing parameters to remote I/O module
Resetting remote I/O module
To cable connection
POINT
using the default settings. (Refer to Section 5.2.1)
from STOP to RUN resets remote I/O stations which satisfy the following
conditions:
• The PLC parameter/network parameter or remote password of a remote I/O
station was corrected but not yet effective due to a reason such as reset of
the remote I/O station.
• A stop error has occurred. (Refer to section 8.3.3.)
written to the remote I/O module: PLC parameters, intelligent function module
parameters, network parameters, and remote password
1: The following settings can be performed for the I/O assignment.
1) Input module for I/O response time.
2) Output module error time output mode.
3) I/O assignment
4) Setting switches for intelligent function modules.
2: Refer to the intelligent function module user's manual for details about
intelligent function module parameters.
Set the following 1
Required
1
2
Set the following
Required
MELSEC-Q
· · · · Section 5.2.1
· · · ·
Section 5.2.1
· · · ·
Section 5.2.1
· · · ·
Section 4.6
5 - 2
5