Table of Contents
Advertisement
Next steps
1.
Replace the expansion card
Installing the expansion card risers
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in
3. If removed,
install the expansion cards into the expansion card
Steps
1. Holding the edges or the touch points, align the holes on the expansion card riser with the guides on the system board.
2. Lower the expansion card riser into place and press the touch points until the expansion card riser connector is fully seated on the
system board connector.
3. Tighten the captive screws on the risers and system if any.
NOTE:
The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Figure 83. Installing the expansion card riser (Riser 1)
130
Installing and removing system components
riser.
Safety instructions
Before working inside your system
on page 46.
on page 47.
risers.
Advertisement
Table of Contents
