Table of Contents
Advertisement
CAUTION:
Do not apply pressure at the center of the memory module; apply pressure at both ends of the memory
module evenly.
CAUTION:
To prevent damage to the memory module or the memory module socket during installation, do not bend
or flex the memory module; insert both ends of the memory module simultaneously.
4. Press the memory module with your thumbs until the ejectors firmly click into place. When the memory module is properly seated in
the socket, the levers on the memory module socket align with the levers on the other sockets that have memory modules installed.
Figure 69. Installing a memory module
Next steps
1. If removed,
install the air
2. Follow the procedure listed in
3. To verify if the memory module has been installed properly, press F2 and navigate to System Setup Main Menu > System BIOS >
Memory Settings. In the Memory Settings screen, the System Memory Size must reflect the updated capacity of the installed
memory.
4. If the System Memory Size is incorrect, one or more of the memory modules may not be installed properly. Ensure that the memory
modules are firmly seated in their sockets.
5. Run the system memory test in system diagnostics.
Processor and heat sink
Removing a heat sink
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. If installed,
remove the air
WARNING:
The heat sink and processor are too hot to touch for some time after the system has been powered off.
Allow the heat sink and processor to cool down before handling them.
94
Installing and removing system components
shroud.
After working inside your system
Safety instructions
Before working inside your system
shroud.
on page 47.
on page 46.
on page 47.
Advertisement
Table of Contents
