Table of Contents
Advertisement
3.
Remove all the
drives.
4. Disconnect all the cables from the rear drive cage.
5. If installed, remove the
Steps
1. Loosen the captive screws that secure the rear drive cage to the system.
2. Push the guide hole tab to release the rear drive cage from the system and lift the rear drive cage away from the system.
Figure 61. Removing the rear drive cage
Next steps
1.
Replace the rear drive
cage.
Installing the rear drive cage
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in
Steps
1. Align the guide and slot on the rear drive module with the slot and guide on the system.
2. Insert the rear drive module on top of the Riser 2a.
3. Tighten the captive screws to secure the rear drive cage to the system.
expansion card
riser.
Safety instructions
Before working inside your system
on page 46.
on page 47.
Installing and removing system components
83
Advertisement
Table of Contents
