Figure 108. Installing the IDSDM module
Next steps
1.
Install the MicroSD
cards.
NOTE:
Reinstall the Micro-SD cards into the same slots based on the labels you had marked on the cards during
removal.
2. Follow the procedure listed in
MicroSD card
Removing the MicroSD card
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3.
Remove the IDSDM
module.
Steps
1. Locate the MicroSD card slot on the IDSDM module, and press the card to partially release it from the slot. For more information about
the slot location, see
System board jumpers and connectors
2. Hold the MicroSD card, and remove it from the slot.
NOTE:
Temporarily label each MicroSD card with the corresponding slot number after removal.
After working inside your system
Safety instructions
Before working inside your system
on page 47.
on page 46.
on page 47.
section.
Installing and removing system components
149