Machine Test - Raven SC1 Calibration & Operation Manual

CHAPTER 8
FIGURE 7. Step Response Test Screen
2. Press the center up arrow. Wait for the actuator to reach the center position.
3. Press the left arrow.
4. Wait for the following fields to populate and record the data:
a. Step Size
b. Delay Time
c. Rise Time
d. Setting Time
e. Overshoot
5. Drive forward 1 - 4 mph with the engine RPM set at 3/4 throttle.
6. Press the center up arrow. Wait for the actuator to reach the center position.
7. Press the rigth arrow.
8. Wait for the following fields to populate and record the data:
a. Step Size
b. Delay Time
c. Rise Time
d. Setting Time
e. Overshoot
9. To test consistency, repeat steps 1 - 8.
NOTE: Once the Step Response Test has been completed, the machine performance reading should fall
within the recommended system settings.

MACHINE TEST

1. The actuator can be moved left and right by pressing and holding the left and right arrows.
2. The following items are found in the drop down menu:
•
Switches
•
Readouts
•
Machine Info
FIGURE 8. Machine Test
66 Raven SC1™/TC1™ (software version 1.5) Calibration & Operation Manual for Towed Implements