Off-Line Indicator; Gps Status Indicator; Tuning Settings - Raven SC1 Calibration & Operation Manual

OFF-LINE INDICATOR

Shown in the top, center of the Home screen, the off-line indicator displays the distance and direction to the
current guidance line.

GPS STATUS INDICATOR

The following are common GPS status or mode information which may occur while the SC1/TC1 system is
engaged:
No GPS information is detected by the SC1/TC1 system.
GPS solution is not converged or an active DTC has been detected.
GPS solution is converged and no active DTCs are detected.
NOTE:
GPS RTK-L or RTK Pro solutions are being used for field guidance. DTCs may be
present.
Select the satellite icon to display the GPS Status screen. Refer to the GPS Status Screen section on page 33 for
additional assistance with the information available on this screen.

TUNING SETTINGS

The following settings and adjustments are displayed on the SC1/TC1 Home screen and may be used during
normal operation to adjust or tune the system:
• Antenna Shift (Tractors Only) - The Antenna Shift settings allows the user to shift the center point of the
antenna relative to the center point of the machine. Negative values indicate that the antenna is located to the
left of the center point.
NOTE: The Antenna Shift value can be verified by marking the hitch pin of the tractor with a flag, setting a
guidance line, turning the machine around 180° degrees, and stopping on the guidance line with the
hitch pin in the same location. If the hitch pin does not line up with the flag, divide the number of
inches [cm] by two and enter that value into the Antenna Shift field. If the hitch pin falls to the right of
the flag, enter a positive Antenna Shift value. If the hitch pin falls to the left of the flag, enter a
negative value.
• Sensitivity - The Sensitivity value determines how aggressively the machine will attempt to remain on the
guidance line. The Sensitivity value is used to fine-tune the SC1/TC1 system. Values range between 50 - 200.
NOTE: If the machine is slow to react after a steering adjustment, increase the Sensitivity setting in
increments of 10. If the machine makes an adjustment too quickly, decrease the Sensitivity value.
• Line Acquire - The Line Acquire value determines the distance away from the set guidance line at which the
machine will make adjustments to come closer to the guidance line. If a low value is entered, the machine will
Routine Machine Operation: Home Screen
Both the steering wheel and GPS icons must be green in order to engage
the SC1/TC1 system.
ROUTINE MACHINE OPERATION
29