Antenna Offsets Settings - Raven SC1 Calibration & Operation Manual

CHAPTER 5
4. Select the Accept button in the lower, right corner of the screen to return to the Machine Settings tab.

ANTENNA OFFSETS SETTINGS

FIGURE 3. Machine Offsets Setup Screen
To adjust the antenna offset measurements:
1. From the SC1/TC1 Home screen, select the Settings Menu button.
2. On the Machine Settings tab, select the Machine Offsets Setup button.
3. The Machine Offsets screen displays the machine-specific measurements that were entered during the system
calibration:
NOTE: Select the Help
• Antenna Height - The Antenna Height is measured from the ground to the middle of the GPS antenna.
• Antenna Center Offset - The Antenna Center Offset position measured from the centerline of the machine to
the center of the GPS antenna. A negative value should be entered if the GPS antenna is located to the left of
the center line.
• Antenna Fore/Aft - The Antenna Fore/Aft position is measured from the rear axle of the machine to the center
of the GPS antenna. A negative value should be entered if the GPS antenna is located behind the rear axle.
• Wheel Base - The Wheel Base is calculated by measuring from the center of the front tire to the center of the
rear tire.
4. Select the Accept button in the lower, right corner of the screen to return to the Machine Settings tab.
38 Raven SC1™/TC1™ (software version 1.5) Calibration & Operation Manual for Tractors and Sprayers
icon for more information about the settings shown on the screen.