Steering Status Screen - Raven SC1 Calibration & Operation Manual

Tractors and sprayers

Hide thumbs Also See for SC1:

Table of Contents

CHAPTER 4

make an adjustment at a greater distance as it drifts away from the guidance line. If a high value is entered, the

machine is quicker to adjust the steering while it is still close to the guidance line. Values range between 1 - 200.

NOTE:

A low value will minimize the risk of over-correction, but it could take longer to acquire the guidance

line. A high value increases the risk of over-correction, but the machine is quicker to re-acquire the

guidance line. If the machine takes too long to acquire the guidance line, increase the Line Acquire

value in increments of 10. If the machine over-shoots the guidance line, decrease the value in

increments of 10.

• Response Speed - The Response Speed determines how quickly the machine will steer when prompted. If the

Response Speed is too high, the steering may become jittery. If the Response Speed is too low, the machine

may wander lazily. Values range between 1 - 255.

NOTE:

If steering becomes jittery, lower the Response Speed value in increments of 10. If steering does not

become jittery, the Response Speed value may be increased in increments of 10 until the desired

Response Speed is reached.

• Last Pass Sensitivity (non-Tractors Only) - The Last Pass Sensitivity determines how tightly the machine tries

to steer on a curved path. Too high of a value will cause the machine to steer to the inside of a curve. Too low

of a value will cause the machine to steer to the outside of a curve. Values range from 1 - 500.

NOTE:

Refer to the Advanced Tuning section on page 40 for assistance with the Last Pass Sensitivity setting

when operating on conventional tractors. Last Pass Sensitivity only adjusts the system performance

on Last Pass and A-B Curve lines.

Adjusting the Last Pass Sensitivity will not affect pivot performance. To adjust Pivot performance, tune

the Response Speed and Sensitivity values.

STEERING STATUS SCREEN

Select the steering wheel icon to display the Steering Status screen. The Steering Status field displays the last exit

code and the reason why steering was disabled.

FIGURE 3. Steering Status Screen

Select the Steering Status History icon next to the Steering Status field to view the history including the times the

system disengaged and why it disengaged.

Raven SC1™/TC1™ (software version 1.5) Calibration & Operation Manual for Tractors and Sprayers

Table of Contents

Tc1