Terrain Compensation Setup; Serial Output Configuration - Raven SC1 Calibration & Operation Manual

Tractors and sprayers

Hide thumbs Also See for SC1:

Table of Contents

TERRAIN COMPENSATION SETUP

FIGURE 3. Terrain Compensation Setup Screen

• Roll, Pitch, Yaw Rate, and Heading - Real-time measurement data used by the 3D terrain compensation

feature.

• Calibrate Terrain Compensation - Begins the terrain compensation process. Refer to Terrain Compensation

Calibration section on page 16 for additional information on completing the Terrain Compensation Calibration.

Select the Accept button in the lower, right corner of the screen to return to the GPS Setup tab.

FIGURE 4. GPS Serial Output/Serial Output Configuration

• GPS Output - Allows the SC1/TC1 system to output NMEA 0183 messages at configurable rates. See the GPS

Serial Output Configuration section on page 56 for details.

• Radio Modem - Select Radio Modem to configure the radio modem. See the Radio Modem Configuration

section on page 54 for information on configuring the Radio Modem.

• RTK Out - Allows the SC1/TC1 system to Output RTK corrections to another ECU.See the RTK Out section on

page 57 for information on configuring the Radio Modem.

Select the Accept button in the lower, right corner of the screen to accept the current output settings displayed

and return to the GPS Setup tab.

GPS Settings: Configure GPS in the SC1/TC1

GPS SETTINGS

Table of Contents

Tc1