Raven SC1 Installation Manual
Case ih steiger/nh t9.xxx (my 16 and newer)
Hide thumbs
Also See for SC1:
- Operation manual (111 pages) ,
- Calibration & operation manual (88 pages) ,
- Calibration and operation manual (79 pages)
Advertisement
RAVEN SC1/TC1 INSTALLATION GUIDE FOR CASE IH STEIGER/NH T9.XXX (MY 16 AND NEWER)
RAVEN SC1/TC1 INSTALLATION GUIDE FOR CASE
IH STEIGER/NH T9.XXX (MY 16 AND NEWER)
This quick guide provides the instructions for the installation of SC1/TC1 on:
Make
Case IH
2016 and Newer Steering Ready
New Holland
2016 and Newer T9.XXX Steering Ready
For calibration and operation information, refer to the Operation Manual (P/N 016-4010-005) included with the kit.
016-5032-169 Rev. A
Year and Model
E33370
Serial Number
All
ZFF403001 & Higher
7/2019
1
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Raven SC1
Summary of Contents for Raven SC1
- Page 1 RAVEN SC1/TC1 INSTALLATION GUIDE FOR CASE IH STEIGER/NH T9.XXX (MY 16 AND NEWER) RAVEN SC1/TC1 INSTALLATION GUIDE FOR CASE IH STEIGER/NH T9.XXX (MY 16 AND NEWER) This quick guide provides the instructions for the installation of SC1/TC1 on: Make Year and Model...
- Page 2 INSTALLATION DIAGRAM Refer to Figure 1 on page 2 for a basic overview of the installation of the SC1/TC1 system. The sections that follow offer more detailed installation procedures. FIGURE 1. SC1/TC1 Cable Diagram for Case IH Steiger (MY 2016+) (P/N 054-5032-169 Rev. B)
- Page 3 RAVEN SC1/TC1 INSTALLATION GUIDE FOR CASE IH STEIGER/NH T9.XXX (MY 16 AND NEWER) ISOBUS DISPLAY CONNECTION 1. Connect the 12-pin connector of the ISOBUS display adapter cable (P/N 115-7300-126) to the existing mating connector behind the trim in the rear-right corner post of the cab.
- Page 4 2. Remove the instruction seat and compartment wall to access the SC1/TC1 mounting location. 3. Mount the SC1/TC1 node (P/N 063-0174-070) to the mounting studs on the node mounting bracket and secure using the supplied 1/4” - 20 flanged lock nuts (P/N 312-1001-168).
- Page 5 MACHINE HARNESS CONNECTIONS 1. Locate the 40-pin Deutsch connectors on the floor inside the instructional seat. 2. Connect the 40-pin Deutsch connector to the mating connector on the SC1/TC1 cable (P/N 115-4010-123). FIGURE 6. ECU Harness Connected to Machine Harness 016-5032-169 Rev.
- Page 6 OPERATION Refer to the SC1/TC1 Calibration and Operation Manual (P/N 016-4010-005) for instructions on configuring, calibrating, and operating SC1/TC1. Please note the location of the master switch and the resume switch on the machine because they are needed for operation.
Need help?
Do you have a question about the SC1 and is the answer not in the manual?
Questions and answers