Routine Machine Operation; Operator Liability - Raven SC1 Calibration & Operation Manual

Tractors and sprayers

Hide thumbs Also See for SC1:

Table of Contents

CHAPTER

NOTE:

The ISO UT must be calibrated specifically for the vehicle before being used to operate the SC1/TC1

system. Refer to the UT operation manual for additional assistance with using your UT display.

Refer to the UT display or Raven field computer operation manual for assistance with setting up and

starting a job, setting guidance lines, and other guidance settings during in-field operations.

The Operator Liability Warning is displayed each time the SC1/TC1 system is powered on. If the operator does not

accept liability, the SC1/TC1 system will be disabled and cannot be reengaged until the liability warning is accepted.

FIGURE 1. Operator Liability Prompt

To proceed with normal operation of the SC1/TC1 GPS and auto-steering features, read and accept the Operator

Liability Warning.

Routine Machine Operation: Operator Liability

R OUTINE MACHINE

C H A P T E R 4

OPERATION

Table of Contents

Tc1