Lifting Of Cutterbars To Headlands; Locking Cutterbars In Lifted Position; Lifting Cutterbars To Transport Position - SaMASZ KDD 861 Operator's Manual

5.3.2. Lifting of cutterbars to headlands

After button (3)
right cutterbar can be operated (lifting to maximum to headland position), e.g. to pass an obstacle.
After button (3) or (4)
previous condition (possibility of operating two cutterbars).
NOTICE:
Function 3 can be enabled on condition the left cutterbar is not locked (diode at button
(5) is off).
Function 4 can be enabled on condition the right cutterbar is not locked (diode at button
is off).
(6)
When function 3 is being enabled, function 4 is disabled, and when function 4 is being
enabled, function 4 is disabled (if enabled).

5.3.3. Locking cutterbars in lifted position

After button (5)
position during operation with only right cutterbar.
After button (6)
position during operation with only left cutterbar.
After button (diode will turn off) is pressed again the lock will be released and the controller
will return to its previous condition (possibility of operating two cutterbars).
When left cutterbar lock is enabled (function 5) function 1 is disabled (unloading should be
adjusted only when cutterbar is in working position) and function 3. Function 5. (left cutterbar
lock) has a priority higher than function 3 and thus it is not possible to select function 3 when the
lock is enabled.
When right cutterbar lock is enabled (function 6) function 2 is disabled. (unloading should
be adjusted only when cutterbar is in working position) and function 4. Function 6. (right
cutterbar locks) has a priority higher than function 4 and thus it is not possible to select function 4
when the lock is enabled.

5.3.4. Lifting cutterbars to transport position

After button (7)
the machine to transport position. When function 7 is enabled other functions (if enabled) are
disabled and locked, and the display alternately shows the following symbols:
and .
Lifting of cutterbars to transport position is possible only when PTO shaft rpm is zero
(protection against machine damage).
When button (7)
position) are activated, and thus machine folding to transport position is disabled.
Operator's manual
or (4) (diode will light up green) is pressed only left cutterbar or
is pressed again (diode will turn off) the controller will return to its
(is pressed (diode blinks red) left cutterbar can be locked in lifted
is pressed (diode blinks red) right cutterbar can be locked in lifted
is pressed, arm position sensors are disabled which allows for folding of
is pressed again the sensors (cutterbars can be lifted only to headland
- 34 -
Double-sided disc mowers
with central suspension