Setting Mower In Position For Driving On Headlands And Transport Position - SaMASZ XT 390 Operator's Manual

WARNING!
Set the pressure in the working system before starting the mower, as otherwise
unloading cylinder may be damaged.
NOTICE:
After switching button (3)
position will follow after 1 minute - even without the need of the operator's action.
WARNING!
Making the oil flow from the tractor to working system will cause increase of
pressure in the system.
NOTICE:
Increasing pressure – lower impact on the ground.
Reducing pressure – bigger impact on the ground.

5.2.2. Setting mower in position for driving on headlands and transport position

To set the mower in position for driving on headlands (Fig. 17) and transport position (Fig. 20) use
button (1) on control panel (Fig. 16) and lever to control the tractor's external hydraulics.
Activation/deactivation of a given button is indicated by activated/deactivated LED (2) above the button
(STOP position).
To set the cutting unit lifting lock for driving on headlands, press button (1)
STOP position above the button is activated. To unlock the cutting unit press button (1)
that LED (2) STOP position above the button is deactivated.
NOTICE:
Activated LED (2) - STOP position above the button (1)
lifting is locked.
Deactivated LED (2) - STOP position above the button (1)
unit can be lifted / lowered freely.
24
XT REAR DISC MOWER
to ON (4) position the automatic override to OFF (5)
OPERATOR'S MANUAL
so that LED (2) -
again so
means that the cutting unit
means that the cutting