Setting Pressure In Unloading System - SaMASZ KDD 861 Operator's Manual

Function 1. Setting pressure in unloading system of left cutterbar
Function 2. Setting pressure in unloading system of right cutterbar
Function 3. Lifting to headlands of left cutterbar
Function 4. Lifting to headlands of right cutterbar
Function 5. Left cutterbar locking
Function 6. Right cutterbar locking
Function 7. Lifting cutterbars to transport position
NOTICE:
The correct control of the machine depends on a properly operating electricity in the tractor.
I. OPERATING MODE

5.3.1. Setting pressure in unloading system

Automatic loading of pressure in loading system of cutterbars to a setpoint is carried out after
pressing button (1)
indicated by corresponding diode flashing red. To set any unloading pressure value, press and hold
button (1) (for left cutterbar) or button (2)
corresponding diode turning red.
NOTICE:
Function 1 or 2 can be enabled only if cutterbar lock is not enabled (diodes at button (5)
or (6) should be off).
When filling accumulators the display shows current pressure value, e.g. "P120" (120 bar).
After reaching a default value loading will stop automatically. After button (1)
pressed again, function 1 or function 2 is disabled.
NOTICE:
If the pressure reduction in automatic mode is not possible, perform this operation in
manual mode.
Operator's manual
ON/OFF
1
3
5
7
Fig. 18. Simplified control panel – description of functions
(for left cutterbar) or button (2) (for right cutterbar) which is
(for right cutterbar) which is indicated by
- 33 -
Double-sided disc mowers
with central suspension
2
4
6
or (2) is