6.5.
Adjusting the cutterbar
Swath width is adjusted with swath guides (1) mounted on the 3-point linkage frame of
the cutterbar (Fig. 34).
In order to adjust the guide, the following should be performed (for: KDD 861 (H), KDD 911
(H), KDD 912 (H), KDD 941 (H)):
loosen locknuts (2) and screws (3),
shift the guide arm (6),
tighten screws (3) and locknuts (2),
loosen locknuts (4) and screws (5),
then adjust shield height and angle (7),
tighten screws (5) and locknuts (4).
Fig. 34. Adjustment of swath guides: 1 - swath guide, 2 - locknuts, 3- arm adjustment screws, 4 - locknuts,
In order to set swath width, adjustment of swath guides (1) should be performed (Fig. 35)
(for: KDD S/ST/SL/SLT (H)):
loosen eye screw (2) of the swath guide,
set the swath guide (1) as needed,
tighten screw (2),
even spreading of swath might be adjusted with wheels (3) the same as it is performed with
guides.
Operator's manual
1
5- shield adjustment screws, 6- guide arm, 7- shield
- 49 -
Double-sided disc mowers
with central suspension
6
4
2
3
5
7