Setting Mower In Transport Position On Headlands; Setting Mower In Vertical Transport Position - SaMASZ KDDR 861 Instruction Manual

1. Control on/ off switch
2. Time display
3. Control emergency stop –
restart of the control will follow after F1
(19) and F2 (18) buttons are pressed
at the same time.
4. Information screen
5. Disabled button
6. Disabled button
7. Disabled button
8. Lifting to headlands of left cutting unit
9. Working position
10. Lifting to headlands of right cutting unit

5.3.1. Setting mower in transport position on headlands

In order to set the mower in transport position on headlands push button (1)
on control panel (Fig. 21).
In order to use one of the cutting units, e.g. right one, lift both of them to transport position on
headlands using button (9)
lock the left one against falling with button (8)
button (10) .
Protection of the chosen cutterbar is signalled with a red diode located over the button which
corresponds to the cutterbar. In order to unlock particular cutterbar push either of buttons (8)
(10) again – unlocking cutterbar protection is then signalled by dimming of the red diode.

5.3.2. Setting mower in vertical transport position

In order to set the mower in vertical transport position (Fig. 25) press button (14)
using the lever to control the tractor's external hydraulics. If near the end of lifting phase the
cutterbars are stopped and mechanical protection devices are not locked then increase pressure in
unloading system. To perform this push button (14)
dimming of the green diode), push button (15)
position until mechanical protection is locked. Next disable control with button (1)
Operator's manual
11. Disabled button
12. Disabled button
13. Disabled button
14. Transport position
15. Pressure modification in unloading system
16. Right cutterbar locking
17. Left cutterbar locking
18. Function button F2 to cancel emergency mode
19. Function button F1 to cancel emergency mode
20. The menu
21. Menu navigation button
22. Menu navigation button
23. Information diode
Switch ON/ OFF of steering panel's
Fig. 22. Steering box
while using the lever to control the tractor's external hydraulics and
. Right cutterbar is protected against falling with
- 24 -
Double-sided mower with central
suspension
"REWERS"
Placement of RS cable to steering
panel
power
again (disabling is then signalled by
and continue setting the mower in transport
and (9)
or
while
.