Lubrication; Risks Present When Lubricating; Cutterbar; Intersecting Axis Gears - SaMASZ KDD 861 Operator's Manual

7. LUBRICATION

7.1.

Risks present when lubricating

To avoid being splashed with pressurized liquid wear protective eyewear with side guards.

When lubricating protect skin against contact with the substance. Therefore use adequate long-

sleeved protective clothing and protective shoes. Use protective gloves, too. In case of a contact
with skin, immediately wash the infected area with plenty of soap water.
Do not allow the product to contaminate water outlets, water courses and soils.

In case of an unintentional release to the environment plug the leak, limit the spillage, and then

collect the oil with non-flammable absorbent material (e.g. sand).
The product is flammable. In case of fire, use adequate fire-extinguishing means (e.g. foam,

water mist, extinguishing powders). Do not use water jets.
Disposal of the used product must be made according to local regulations. Improper disposal of

the used oil poses danger to the environment.
7.2.

Cutterbar

Refilling oil in the cutterbar is done through the inlet A (Fig. 49). Proper oil level is 0.2" -
0.3" from the cutterbar bottom. In order to drain oil from the cutterbar dismount the cutterbar
enclosure by releasing bolts (B). Oil capacities are in Tab. 8.
Tab. 8. Oil capacities
Model
KDD 861 (S/SL/W (H) (T)) - 8,60 m
KDD 911 (S/SL (H)) - 9,10 m
KDD 912 (H) - 9,10 m
KDD 941 (S/SL/W (H) (T)) - 9,40 m
A
Fig. 49. Points of oil inspection and replacement in cutterbar
7.3.

Intersecting axis gears

Every day before starting work please check the oil level and, if needed, please refill after
having removed the vent A on the top of the gear (Fig. 50). The oil level can be checked through
check opening B on the side of the gear. Please refill the oil until it is visible in the check opening
B. Check oil level when the cutterbar is on the ground. Removing the worked oil from the gearbox
is done through the outlet C.
Operator's manual
Oil capacity
Oil type
[US gal lqd]
2 x 1.6
80W90
2 x 1.7
- 58 -
Double-sided disc mowers
with central suspension
Lubrication frequency
After first 50 h of operation, then after
next 500 h (or at least once a year)
B