Control Panel - SaMASZ KDD 861 Operator's Manual

WARNING!
Handle all parts with utmost care. Never place your hands or fingers between
one part and the other. Wear safety clothes such as gloves, protective footwear
and goggles. The operation of shortening must be carried out with the utmost
care as the PTO shaft will have to be replaced if the telescopic shafts are
shortened to an excessive extent.
WARNING!
The PTO shaft should be mounted only during operation time and
disconnected from tractor PTO for transport and service.
NOTICE:
The manufacturer declines all liability for damage caused by an incorrectly fitted or used
PTO shaft.
WARNING!
Use the machines with PTO shafts designed to drive them. Before the work
begins, check the safety guards (in tractor, mower and PTO shaft), if they are
placed correctly and are not damaged. Damaged or lost parts must be replaced
with genuine ones. Make sure the PTO shaft is properly mounted. It is
forbidden to approach the rotating parts, because it may lead to serious injuries
or even death. All service and repair operations must be done only after the
tractor engine has been stopped and ignition key off, all rotating parts have
come to the complete standstill and the cutterbar is on the ground. Before
the operation begins, read operator's manuals of both the machine and PTO
shaft.
5.2.

Control panel

Controlling the mower is performed with use of one of the tractor's hydraulic sections and
control panel located in the tractor's cabin. The action to be performed is chosen by the operator
with buttons on the panel which controls the tractor's hydraulics. Push the button (1)
in order to enable controlling. Pushing the button is signaled with a diode located over the button.
Operator's manual
Fig. 15. Instruction of PTO shaft shortening
- 29 -
Double-sided disc mowers
with central suspension
(Fig. 16)