Setting Pressure In Unloading System; Lifting Of Cutterbars To Headlands; Locking Cutterbars In Lifted Position - SaMASZ KDD 861 Operator's Manual

OPERATOR'S MANUAL
I. OPERATING MODE

5.3.1. Setting pressure in unloading system

Automatic loading of pressure in loading system of cutterbars to a setpoint is carried out after
pressing button (1)
corresponding diode flashing red. To set any unloading pressure value, press and hold button (1)
(for left cutterbar) or button (2)
turning red.
WARNING!
Function 1 or 2 can be enabled only if cutterbar lock is not enabled (diodes at
button (5)
When filling accumulators the display shows current pressure value, e.g. "P120" (120 bar). After
reaching a default value loading will stop automatically. After button (1)
function 1 or function 2 is disabled.
WARNING!
If the pressure reduction in automatic mode is not possible, perform this
operation in manual mode.

5.3.2. Lifting of cutterbars to headlands

After button (3)
cutterbar can be operated (lifting to maximum to headland position), e.g. to pass an obstacle. After
button (3) or (4)
condition (possibility of operating two cutterbars).
WARNING!
Function 3 can be enabled on condition the left cutterbar is not locked (diode at
button (5)
Function 4 can be enabled on condition the right cutterbar is not locked (diode at
button (6)
When function 3 is being enabled, function 4 is disabled, and when function 4 is being enabled,
function 4 is disabled (if enabled).

5.3.3. Locking cutterbars in lifted position

After button (5)
during operation with only right cutterbar.
After button (6)
during operation with only left cutterbar.
After button (diode will turn off) is pressed again the lock will be released and the controller will
return to its previous condition (possibility of operating two cutterbars).
When left cutterbar lock is enabled (function 5) function 1 is disabled (unloading should be
adjusted only when cutterbar is in working position) and function 3. Function 5. (left cutterbar lock)
has a priority higher than function 3 and thus it is not possible to select function 3 when the lock is
enabled.
DOUBLE-SIDED MOWER
(for left cutterbar) or button (2)
(for right cutterbar) which is indicated by corresponding diode
or (6) should be off).
or (4) (diode will light up green) is pressed only left cutterbar or right
is pressed again (diode will turn off) the controller will return to its previous
is off).
is off).
(is pressed (diode blinks red) left cutterbar can be locked in lifted position
is pressed (diode blinks red) right cutterbar can be locked in lifted position
KDD
(for right cutterbar) which is indicated by
or (2) is pressed again,
37