Conveyor Belt Replacement And Adjustment Instruction - SaMASZ KDD 861 Operator's Manual

6.10.2. Conveyor belt replacement and adjustment instruction

Mower KDD with conveyors must be suspended onto tractor. Lean the mower with use of
upper connector (cylinder) as far as you can to the front – in order to increase the distance between
conveyor and the ground.
I. The adjustment of the belt conveyor should be done only when the conveyor is in its
working position (horizontal).
1. Using a marker, mark lines on millimeter measures – decal 77 (if belts worked well).
2. Loosen tightening roller mechanism – screws M10 - S
screw M12 – S by approx. 3'11" (Fig. 44).
2
Driving roller hydraulic
engine
(do not adjust)
II. Steps to be taken when transporting in vertical position. Mower shall be leaned to the front
so the distance between conveyor and the ground is approx. 3' 3".
1. Loosen screws M10 – S
(Fig. 45).
S
S
1
Operator's manual
, nuts M12 – N
1
2
N
2
, nuts M12 – N
1
S
1
N
Fig. 44.
adjustment screws M12 – S
2,
Fig. 45.
- 56 -
Double-sided disc mowers
with central suspension
and loosen adjustment
2,
measure
1"
of front tensioners
2
S
S
1
N
2
S
2
2