a)
To replace oil in gears:
Prepare an adequate tank for waste oil to be disposed of at a specialized plant,
Open refill vent A and drain vent C (Fig. 50),
Drain oils from the gear,
Close drain vent C,
Refill the oil level until it is visible in the check opening B,
Close refill vent A.
Tab. 9. Oil capacities in intersecting axis gears
Model
KDD 861 (H)
KDD 911 (H)
KDD 912 (H)
KDD 941 (H)
KDD 861 S/SL (H)
KDD 941 S/SL (H)
KDD 861 W (H)
KDD 941 W (H)
KDD 861 S/SL T (H)
KDD 941 S/SL T (H)
KDD 861 WT (H)
KDD 941 WT (H)
WARNING!
The above instructions should be strictly followed. If the discs in the cutterbar
rotate loosely, do not worry about high intersecting axis gear temperature;
after long working time, it may reach as much as 100
7.4. Swath rollers cog gear
Before checking the oil level in swath rollers cog gear unscrew bolts holding protective
housing. Please check the oil level and, if needed, please refill after having removed the vent A on
the top of the gearbox (Fig. 51) The oil level can be checked through the check opening B on the
side of the gear. Please refill the oil until it is visible in the check opening B. The oil level: about
0.5 l. Check oil level when the cutterbar is on the ground. Removing the worked oil from
the gearbox is done through the outlet C.
Operator's manual
A
B
C
Fig. 50. Intersecting axis gears oil
Gears
054-02.10CB.R
055-02-10CB.R
118-03.111.LS
130-01.113.LS
052-02.0100AB.L
095-07.1FL.RS
138-03.1D13.LS
052-02.0100AB.L
053-02.0100AB.L
095-07.1FL.RS
b)
Oil capacity
Oil type
[US gal lqd]
0.3
0.7
1.6
SAE 80W/90,
0.65
API GL-4
0.3
1.6
0.65
0.3
- 59 -
Double-sided disc mowers
with central suspension
A
B
C
Lubrication frequency
After first 50 h of
operation, then after
next 500 h (or at least
once a year)
o
C.