Fig. 35. Tandem suspension cushioning short uneven ground sections
5.10. Lifting the rake on turns
When driving back through already formed rows, lift the rake to its transport position. Perform
the following:
Operate single-side controller for lifting until the machine has been fully lifted,
Drive back or drive over the formed rows,
Operate single-side controller for lowering until the machine has been fully lowered,
Set the controller in zero position.
WARNING:
Due to the specific in-line design of the machine it is forbidden to take sharp
turns with the rotors lifted. Taking too sharp a turn may cause a fall or a
damage to the machine. The risk is analyzed in Fig. 36.
Fig. 36. Risk of falling due to torque M when taking a tight turn with rotors lifted
Operator's manual
M
- 30 -
Two-rotor in-line rake
DUO 680
DUO 740
F
F