Mowers Fitted With Controller; Mowers Without Controller; Mounting Pto Shaft - SaMASZ KDD 861 Operator's Manual

5.1.1.2.

Mowers fitted with controller

In all models of mowers fitted with controller, one hydraulic hose is used for connecting the
mower to the tractor. The hose has filter (Fig. 14b hose A). In such mowers it is enough if the
tractor has one floating hydraulic section available.
5.1.1.3.

Mowers without controller

In all models of mowers without controller, three hydraulic hoses are used for connecting the
mower to the tractor (Fig. 14c). Hose A (red) with ball valve is used for lifting of cutting units to
transport position and for setting pressure in support assembly. It should be connected to the
floating section of the tractor. Hose B (green) with choke valve is used for lifting of left cutting
unit on headlands, and hose C (yellow) also with choke valve is used for lifting of right cutting unit
on headlands. In such mowers it is enough if the tractor has three pairs of hydraulic outputs (one
with free oil flow).
A
B
Fig. 14c. Connecting hydraulic hoses to tractor from mower with conditioners/rollers

5.1.2. Mounting PTO shaft

PTO shaft's end with overrunning clutch should be mounted on mower's side.
When connecting PTO shaft between tractor and mower make sure that external guard tube of
the shaft is on the tractor's side. The PTO shaft plastic guards have to be secured by fastening their
small chains to immovable parts of tractor and mower. The PTO shaft must operate at the lowest
possible angle. This will ensure that both shaft and the machine last as long as possible.
NOTICE:
If need be, shorten the PTO haft according to its operator's manual given by the shaft's
manufacturer (Fig. 15).
Operator's manual
in version without controller
- 28 -
Double-sided disc mowers
with central suspension
C