Setting Mower In Transport Position On Headlands; Setting Mower In Vertical Transport Position - SaMASZ KDD 860 W Operator's Manual

I
1
Fig. 19b. Placement of steering box and cable attachment socket RS (1) on KDD mowers, I – mowers

5.2.1. Setting mower in transport position on headlands

In order to set the mower in transport position on headlands, push button (1)
To use one of the cutterbars such as the right one, lift both of them to transport position on
headlands and prevent the left one against falling with button (13)
protected against falling with button (14)
Protection of the chosen cutterbar is signalled with a red diode located over the button which
corresponds to the cutterbar. In order to unlock a particular cutterbar, push either buttons (13)
(14) again – unlocking cutterbar protection is then signalled by dimming of the red diode.

5.2.2. Setting mower in vertical transport position

In order to set mower in vertical transport position (Fig. 23), push button (5)
lifting phase and the cutterbars are stopped and mechanical protection devices are not locked, then
increase pressure in unloading system. To do this, push button (5)
signalled by dimming of the green diode), push button (4)
transport position until mechanical protection is locked. Next, disable control by pushing button (1)
.
Operator's manual
ON/OFF switch for steering panel
Fig. 19a. Steering box
without belt conveyors, II – mowers with belt conveyors
.
Double-sided disc mowers
with central suspension
RS cable attachment to steering panel
power
II
1
and continue setting the mower in
- 28 -
on Fig. 18.
. The right cutterbar is
. If near the end of
again (disabling is then
or