Operating Control Panel - SaMASZ KW 141 Operator's Manual

CAUTION!
When maneuvering the operating head pay attention so as not to hit it against
a tractor or the extension arm (Fig. 39).

5.4.3. Operating control panel

Tilting with the machine's arms is performed with use of hydraulic cylinders controlled from
control panel located in the tractor's cabin. On the panel there is the machine diagram placed with
numbering of each cylinder (Fig. 40) and corresponding control levers.
WARNING!
Minimum bending radius of cords of control panel is 7.9 in / 20 cm. The cords
set with lower radius will break.
40
KWT, CAMEL, KOLIBER, KW, LAMA
Fig. 38. Working position for KWT 651
Fig. 39. Risk of head collision with tractor or extension arm
REAR EXTENSION ARMS OPERATOR'S MANUAL