Use Of Rake; Mounting Rake On Tractor; Control Panel - SaMASZ TANGO 730 Operator's Manual

Two-rotor rake

Hide thumbs Also See for TANGO 730:

Table of Contents

5. USE OF RAKE

5.1.

Rake TANGO 730 cooperates with tractors with power from 60

The rake should be attached to a tractor with use of tractor's lower pull-cables as provided in

Fig. 8. For this purpose drive the tractor at the rake's catch, and then place hangers W of

tractor's lower pull-cables on pins S on the rake's linkage.

Once the rake is mounted turn support leg back (Fig. 8).

Connect hydraulic hoses.

Connect machine's controller to tractor's lighter outlet (12V) by means of a plug and a three-pin

plug to socket on the rake's linkage. Fix the controller in tractor's cabin by means of magnetic

holder in a visible place.

Connect the machine's lighting cables to the tractor and check the lights for operation.

Connect telescopic articulated shaft. If need be shorten the shaft as per item 5.4.

Controller (Fig. 9) enables switching the rake's working units to working position (lowering)

and transport position (lifting). During the machine operation, if diode (1) is lit the sequential lifting

and lowering of working units function is enabled. Button (C) is for switching between the panel

functions. Once button (C) is pressed the diode (1) goes off, a diode (2) will light up to indicate

deactivation of sequential lifting and lowering function and thus activation of folding the machine

for transport and unfolding it for operation function. Once this option is enabled the working units

will fold and unfold steadily. Note: once diode (2) lights up the function remains active for 60

seconds. This time is sufficient to fold the machine to transport position or unfold it to working

position. As the 60 s time elapses the panel will go to sequential operation mode.

Instruction manual

Fig. 8. Rake mounted on tractor

Fig. 9. Control panel

- 14 -

Two rotor rake

TANGO

HP.

Table of Contents