Operating Control Panel - SaMASZ KWT 550 Operator's Manual

5.5.1. Operating control panel

Tilting with the machine's arms is performed with use of hydraulic cylinders controlled from
control panel located in the tractor's cabin. On the panel there is the machine diagram placed with
numbering of each cylinder (Fig. 41) and corresponding control levers.
CAUTION:
Minimum bending radius of cords is 20 cm. The cords set with lower radius
will break.
I. Control panel with mechanical controlling
Controlling the machine is performed with use of lever in control panel Fig. 41, marked with
corresponding pictograms:
a) Lever A – adjusting the cutterbar vertically/horizontally with "floating" position – cylinder
b) Lever B – adjusting the machine in working/transport position (rotation of arms) – cylinder
c) Joystick C – controls the arms – cylinder
d) Lever D – starting/stopping hydraulic engine
Lever D features function of sudden rear direction change locking. Lock in position as on
Fig. 42a allows right rears to be switched on only. Lock in position as on Fig. 42b is used for
turning opposite rears on.
Non-shaded pointers
Shaded pointers
Operator's manual
Fig. 40. Cords set-up
and
1
(lever down) – turning right rears on,
(lever up) – position for turning opposite rears on in order to
clean the shaft from wound up material.
- 37 -
Flail head
;
2
23
driving the cutterbar;
Arm
4
14
;
;