WARNING!
The PTO shaft should be mounted only during operation time and
disconnected from tractor PTO for transport and service.
WARNING!
When changing the tractor, with which the machine operates, control the
length of PTO shaft again, as otherwise the machine can be damaged.
WARNING!
Use the machines with PTO shafts designed to drive them. Before the work
begins, check the safety guards (in tractor, mower and PTO shaft), if they are
placed correctly and are not damaged. Damaged or lost parts must be replaced
with genuine ones. Make sure the PTO shaft is properly mounted. It is
forbidden to approach the rotating parts, because it may lead to serious injuries
or even death. All service and repair operations must be done only after the
tractor engine has been stopped and ignition key off, all rotating parts have
come to the complete standstill and the cutterbar is on the ground. Before
the operation begins, read operator's manuals of both the machine
and PTO shaft.
5.2.
Control panel
Mower's controlling is performed with use of one of tractor's hydraulic sections and control
panel located in tractor's cabin. Push the button (1)
Pushing the button is signalled with diode (23) located over the button.
Operator's manual
Fig. 15. Instruction of PTO shaft shortening
- 27 -
Double-sided disc mowers
with central suspension
(Fig. 16) in order to enable controlling.