Control Panel - SaMASZ TANGO 730 Operator's Manual

Two rotor rake
Instruction manual
TANGO
S
W
Fig. 7. Rake mounted on tractor
After the rake has been attached to tractor, check the balance and steerability of tractor -
rake set. In order to perform this, the tractor should be weighed and then driven onto the scales with
the tractor's front axis only (tedder must be in transport position, so lifted upwards). If the pressure
on the front axis is at least 20% of the whole set's pressure, it means the set is stable. If not, the
front axis should be balanced.

5.1.1. Control panel

Controller (Fig. 8) enables switching the rake's working units to working position (lowering)
and transport position (lifting). During the machine operation, if diode (1) is lit the sequential lifting
and lowering of working units function is enabled. Button (C) is for switching between the panel
functions. Once button (C) is pressed the diode (1) goes off, a diode (2) will light up to indicate
deactivation of sequential lifting and lowering function and thus activation of folding the machine
for transport and unfolding it for operation function. Once this option is enabled the working units
will fold and unfold steadily.
CAUTION: once diode (2) lights up the function remains active for 60 seconds. This time is
sufficient to fold the machine to transport position or unfold it to working position. As the 60 s time
elapses the panel will go to sequential operation mode.
1 2
Fig. 8. Control panel
- 14 -