Control Panel Gigacut - SaMASZ KDD 861 Operator's Manual

WARNING!
Before the operation begins, read operator's manuals of both the machine
and PTO shaft.
WARNING!
If need be, shorten the PTO haft according to its operator's manual given by the
shaft's manufacturer (Fig. 15).
WARNING!
The PTO shaft should be mounted only during operation time and disconnected
from tractor PTO for transport and service.
WARNING!
Use the machines with PTO shafts designed to drive them. Before the work
begins, check the safety guards (in tractor, mower and PTO shaft), if they are
placed correctly and are not damaged. Damaged or lost parts must be replaced
with genuine ones. Make sure the PTO shaft is properly mounted. It is forbidden
to approach the rotating parts, because it may lead to serious injuries or even
death. All service and repair operations must be done only after the tractor engine
has been stopped and ignition key off, all rotating parts have come to
the complete standstill and the cutterbar is on the ground.
WARNING!
When changing the tractor, with which the machine operates, control the length
of PTO shaft again, as otherwise the machine can be damaged.

Control panel GigaCut

Control system comprises controller (referred to as ECU) controls (sensors, solenoid valves, etc.)
installed on the machine and control panel (Fig. 16) mounted in the tractor cabin. Hydraulic system of
the machine must be connected to one section and this must be section with floating function.
28
KDD
Fig. 15. Instruction of PTO shaft shortening
DOUBLE-SIDED MOWER OPERATOR'S MANUAL