Oil Level In The Gearbox; Repairs: Welding; Structural Changes; Electronic Control - SaMASZ UNO 600 Operator's Manual

Tedder wagons optifeed

Hide thumbs Also See for UNO 600:

Table of Contents

9.9.

Every week oil level in the gearbox should be checked. It should oscillate between signs

MIN and MAX.

Change the oil every 6 months. Make sure there is no water in the oil.

Oil used by manufacturer: Gearbox oil F-15.

9.10.

Under no circumstances should the electric current flow through parts of weighing control

system. Open the box; disconnect wires of weight control system and sensor cords. Moreover,

welder clamps should be placed in the near vicinity of the welded place.

9.11.

No kind of structural changes should be made in OptiFEED fodder wagon without prior

arrangement with the manufacturer. Manufacturer is not responsible for damages, breakdowns, or

improper functioning caused by structural changes made.

9.12.

Applies to mixer feeders equipped with optional electronic control.

Electronic control for mixer feeder OptiFEED is offered as optional equipment. Regardless

of the model and size, each mixer feeder can have electronic control to facilitate and improve the

machine control while preparing a uniform feed mix.

Controlling individual stages in the operation of the mixer feeder equipped with optional

electronic control is done by means of a clear-view control panel. The control panel also has push-

buttons with markings showing their corresponding functions.

The electronic control panel is equipped with a large, clear display to show messages

regarding the machine's current work mode and on-screen buttons for individual functions. Below is

detailed description of the control panel "push and hold" buttons.

Operating manual

OIL LEVEL IN THE GEARBOX

Fig. 16. Electronic control panel for mixer feeder

Tedder wagons OptiFEED

Table of Contents