Table of Contents
Advertisement
CAUTION:
Use the machines with PTO shafts designed to drive them. Before the work begins,
check the safety guards (in tractor, mower and PTO shaft), if they are placed
correctly and are not damaged. Damaged or lost parts must be replaced with
genuine ones. Make sure the PTO shaft is properly mounted. It is forbidden to
approach the rotating parts, because it may lead to serious injuries or even death.
All service and repair operations must be done only after the tractor engine has
been stopped and ignition key off, all rotating parts have come to the complete
standstill and the cutterbar is on the ground. Before the operation begins, read
operator's manuals of both the machine and PTO shaft.
5.2. Control panel
Controlling the mower is performed with use of one of the tractor's hydraulic sections and
control panel located in the tractor's cabin. The action to be performed is chosen by the operator
with buttons on the panel which controls the tractor's hydraulics. Push the button (1)
in order to enable controlling. Pushing the button is signalled with a diode located over the button.
3
15
1
23
21
20
1. Control on/ off switch
2. Information screen
3. Emergency control stopping–
controlling is enabled again
once buttons F1 (16) and F2 (17)
are pushed at the same time.
4. Pressure modification in unloading system 17. F2 Function button
5. Transport position
6. Working position
7. Left conveyor starting
8. Right conveyor starting
9. Increasing rotary speed of conveyors
10. Decreasing rotary speed of conveyors
Operator's manual
2
11
6
12
19
16
18
Fig. 18. Control panel – functions
Double-sided disc mowers
with central suspension
22
7
17
13
11. Left cutterbar lifting
12. Right cutterbar lifting
13. Left cutterbar locking
14. Right cutterbar locking
15. Time setting
16. F1 Function button
18. Menu
19. Function buton/enter
20. Function buton/escape
21. Inactive button
22. Inactive button
23. Information diode
- 27 -
(Fig. 18)
3
8
14
9
10
5
4
Advertisement
Table of Contents
