Removing The Extraction Cone From The Ion Block - Waters Xevo TQ MS Operator And Maintenance Manual

Removing the extraction cone from the ion block

Required materials
• Chemical-resistant, powder-free gloves
• Combined 2.5-mm Allen wrench and cone extraction tool
To remove the extraction cone from the ion block
Warning:
biohazardous and/or toxic materials. Always wear
chemical-resistant, powder-free gloves while performing this
procedure.
1. On the rear of the ion block, use the combined 2.5-mm Allen wrench and
cone extraction tool to loosen the captive screws securing the 2 PEEK
extraction cone retainer clips, and then rotate the retainer clips clear of
the extraction cone.
The ion block components can be contaminated with
Extraction cone handle insulator
Securing screw Extraction cone
Cleaning the extraction cone
Retainer clip
rotated clear of the
extraction cone
4-37