Huawei FusionModule5000 Maintenance Manual page 192

FusionModule5000 Smart Modular Data Center
Maintenance Guide (ECC800)
(1) White rubber washer
Step 7 (Optional) Adjust the magnet.
If the magnet does not work properly after power-on, check that:
1.
2.
3.
If any of the preceding conditions is not met, troubleshoot the magnet as follows:
1.
2.
3.
4.
Issue 01 (2019-03-05)
Figure 5-84 Installing a magnet
The magnet provides magnetic force by attaching magnetizable iron parts to it.
The double-door magnetic lock is aligned with the magnet face-to-face.
No gap exists between the double-door magnetic lock and the magnet.
Check the circuit and rectify any circuit fault.
Adjust the magnet base and the door panel to align the magnetic lock with the magnet
face-to-face. Ensure that the deviation is minimum.
If a gap exists between the double-door magnetic lock and the magnet, rectify the fault as
shown by (1) in Figure 5-85.
If the magnet is not level, use a spacer shown by (2) in
levelness.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
5 Parts Replacement
Figure 5-85 to adjust the magnet
184