Huawei FusionModule5000 Maintenance Manual page 191

FusionModule5000 Smart Modular Data Center
Maintenance Guide (ECC800)
1.
2.
3.
When securing the magnet to the door panel, do not over-tighten the screws so that the white rubber
washer is elastic. The washer will adjust the magnet to a correct position because of its elasticity.
Issue 01 (2019-03-05)
Remove the magnet from the door, as shown in
Figure 5-82 Removing a magnet
Take out the magnet from the new magnetic lock fitting bag, and insert the positioning
pins of the magnet into the magnet using a rubber mallet, as shown in
Figure 5-83 Installing positioning pins of a magnet
Insert the assembled magnet into the magnetic lock base on the revolving door, and
secure the magnet to the door using the screws on the door and the white rubber washer
delivered with the magnet, as shown in
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Figure 5-82.
Figure 5-84.
5 Parts Replacement
Figure 5-83.
183