Huawei FusionModule5000 Maintenance Manual page 170

FusionModule5000 Smart Modular Data Center
Maintenance Guide (ECC800)
Procedure
Step 1 Put on an ESD wrist strap (or ESD gloves) and insert the ground terminal into the ESD jack in
the cabinet.
Step 2 Remove the faulty hard disk.
1.
2.
3.
Figure 5-59 Removing a hard disk
Step 3 Install a new hard disk.
1.
2.
3.
Issue 01 (2019-03-05)
Press the button on the hard disk panel to open the ejector lever, as shown by (1) in
Figure 5-59.
Pull out the hard disk for about 3 cm, wait for 30 seconds at least until the hard disk
stops rotating, and pull it out, as shown by (2) in
Use a screwdriver to loosen the screws from the hard disk and remove the hard disk, as
shown by (3) and (4) in
Secure the hard disk to the front panel using a screwdriver, as shown by (1) and (2) in
Figure 5-60.
Push the hard disk into the subrack along the guide rails until it cannot move forwards,
as shown by (3) in Figure
Close the ejector lever and push the hard disk in position, as shown by (4) in
5-60.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Figure 5-59.
5-60.
5 Parts Replacement
Figure 5-59.
Figure
162