Power Up; Panel Controls - Pace ST 40A Operation & Maintenance Manual

Operation

Power Up

3. Turn the Power Switch ON ("1").
If the Power Receptacle does not have a handpiece attached, "Open Sensor
Check Handpiece" will be displayed on the Digital Readout.

Panel Controls

4. With a handpiece connected to the system
the Digital Readout will display the
stored Set Tip Temperature and the
Operating Tip Temperature. If the Digital
Readout displays "Set Temp = OFF"
(factory setting), proceed to step 5.
Allow sufficient time for the handpiece to
heat and the Operating Tip Temperature
("Temp = XXX") to stabilize at the Set Tip
Temperature. The Digital Readout will
now display only the Operating Tip
Temperature (plus "**" if the stored Tip
Offset Constant value is greater than 0).
22
NOTE
C
XXX
C
XXX
C
XXX